S74 MPA Plus

S74 Wire Feeder designed for Pulse Welding all materials including aluminum

951291_S74MPA_Plus_Manual

SKU: 951291 Category:

Description

  • Four weld programs allow the operators to store four independent welding parameters reducing welding setup time. (Four programs available per side on dual feeder.)
  • Adjustable run-in control for improved arc starts.
  • Adjustable weld sequence control gives operator complete control of the welding parameters: preflow, run-in, weld time, crater, burnback and postflow.
  • Welding process range control locks parameters at a set percentage of welding parameters to ensure welding proce dures and quality standards are maintained on the shop floor.
  • Dual schedule, trigger dual schedule and trigger program select allows operator to switch welding parameters without readjusting machine, eliminating downtime and enhancing quality.
  • Push-pull capability provides consistent, versatile and dependable aluminum wire feeding over greater distances
  • Synergic pulsed MIG operation with MPa power supplies. Provides communication between the power source, feeder and gun. As wire speed increases/decreases, the pulse parameters also increase/decrease to match the right amount of power needed.
  • Trigger schedule select allows the operator to select the alternative schedule by quickly tapping the gun trigger when not welding. When optimized with MPa power sources the operator can also switch from MIG to pulsed MIG.</li>
  • Profile Pulse&trade; provides TIG appearance with MIG simplicity and productivity. Achieve &ldquo;stacked dime&rdquo; weld bead appearance without back-stepping. Profile Pulse frequency can be changed to increase or decrease the spacing between the ripple pattern to achieve the desired weld appearance</li>
  • Accu-Mate&trade; properly seats the power pin for best feeding performance and prevents Accu-Mate grooved MIG guns from sliding in the casting.